Caution:  Sulphur vaporization can damage your controller!  To protect your controller, it is important to disconnect and cover the Atlas 3 by wrapping with a plastic bag OR remove the controller from the grow area while using sulphur vaporizers in your grow room.  Titan Controls can analyze and detect CO2 components that have been contaminated & damaged by sulphur vaporization.  We reserve the right to not repair these defective units under warranty, however we can repair & return your Atlas 3 for a fee, if you'd like

Q: Does my Titan controller need to be calibrated?

A: No, your controller has been factory calibrated and is ready for service when you take it out of the box.  Each unit will provide years of use and will maintain its settings without any further changes required.  Please contact us if you think that your calibration is not correct and we can help you out.

Q:  My CO2 monitor/controller is reading really high all the time.  What's wrong with it?

A:  We hear this a lot.  The main issue is the 2000 ppm of CO2 we exhale when we're breathing.  If you're in your room and you see that the ppm is high, leave the area for an hour or so and turn off your CO2 source, then peek your head in and check the reading, it should be reading under 1000 ppm mattering on how well your room is sealed.  After observing your CO2 Monitor/Controller for awhile, you'll start to see what your normal ppm level is in your room.  The normal outdoor ppm is 400 ppm to 600 ppm based on where you live (city vs. rural).

Q:  Should I run my CO2 at night?

A:  No, you shouldn't.  Plants photosynthesize CO2 only during the daylight hours.  At night, the plants expire CO2 and have no use for CO2.  So, save yourself some money and only dose CO2 during daylight hours when it does the most good for the plants.

Q = I'm getting "Er.1" showing on my Atlas 3 LCD display.  What does it mean?

A = This is 'Error Code 1' for the Atlas 3.  This is a problem with the  CO2 sensor in the controller.  To fix it, just turn off the power, wait five seconds and then reactivate the controller.  This should take care of it.  If not, give us a call at 888-808-4826 and we'll help you out.

Q = I'm getting "Er.8" showing alternately with the sensor values on my Atlas 3 LCD display.  What does it mean?

A = This is 'Error Code 8' for the Atlas 3. This is a memory corruption problem and all your preferred settings will be reset to the default factory settings.  To fix it, re-enter your preferred settings and this should take care of it.  If not, give us a call at 888-808-4826 and we'll help you out.