The Atlas® 8 is a digital CO2 monitor/controller. Once the CO2 level has reached your desired set point it will disable the CO2 device. It features a photocell to ensure daytime only dosing of CO2 via a generator or regulator. This controller comes with a 15 ft remote sensor that houses the photocell and CO2 sniffer. Besides having traditional injection capabilities, it also features fuzzy logic programming. Fuzzy logic applies constant calculations to the output controlling your CO2 regulator to ensure that you do not undershoot or overshoot your predetermined set point. The CO2 min/max can also be viewed on the LCD. Enclosure resists dust, rust, and moisture. 15 Amps maximum/120 Volts/60 Hz.
The Atlas® 8 is a digital CO2 monitor and controller.
Photocell to ensure 'daytime only' dosing of CO2 via a
generator or regulator.
15 foot remote sensor.
Features fuzzy logic programming. Fuzzy logic applies constant
calculations to the output controlling your CO2 regulator to ensure
that you do not undershoot or over shoot your predetermined set
The CO2 min/max can be viewed on the LCD.
Plastic enclosure resists dust, rust and moisture.
If at any time you wish to reset the Atlas® 8 to its original factory settings, simply press and hold the 'Enter/Reset' and 'DOWN' buttons simultaneously until the display reads f.Set. Press AND HOLD the 'Enter/Reset' button again FOR TWO SECONDS to restore the controller to factory settings. Once the reset is complete the screen will display doNE.
Override function for Atlas 8
To activate the override function on the Atlas 8, use the supplied 12v power supply. This power supply is only to be used if using a separate controller/thermostat/temperature controlling device. The override function is to be used to keep your CO2 and exhaust fan from running simultaneously. For more information, refer to page 6 in the Atlas 8 instruction booklet supplied with your unit.